Ductless Split – Ceiling Mount 4000

$4,699.00

    • No
    • Yes (+$339)
    • No
    • Yes
    • No
    • Yes (+$100)
    Clear
Share this product

Description

At WhisperKOOL, we have created a ceiling-mounted split system evaporator because we want you to experience KOOL without seeing it. Your wine should be the center of attention, not a cooling unit.

Note: A qualified HVAC-R technician is required for installation. Failure to have the system installed by a qualified technician will void the warranty.

BTU/h Rating

4000

The BTU/h value shown here is a theoretical number. There are often circumstances under which a cellar design may require a larger unit due to variables not accounted for in the formula. For example, these variables could be building materials (such as glass, stone, concrete, etc.) which do not offer the insulation capacity required to maintain the optimal cellar environment. We recommend purchasing a unit with a larger capacity to compensate for these unaccounted-for variables. An undersized unit can lead to premature failure and will most likely prevent the cellar from reaching your desired temperature.

Cellar Wizard

For more specific calculations, we have a tool which accounts for these variables. Please utilize this tool in order to ensure you are selecting the proper cooling unit for your application. Our tool is called the Cellar Wizard.

Specifications

Cellar Size:
Approx. 1000 cu. ft. when cellar is fully insulated and sealed with a proper vapor barrier (each wine cellar is unique and has specific cooling requirements; heat load calculations should always be performed prior to selecting a cooling unit)
BTU/h w/85°F air entering condenser coil:
4000
Dimensions:
Evaporator: 35.75”L x 14.5”W x 12.75”H, condenser: 16.08”L x 16.23”W x 12.61"H
Refrigerant:
R-134a
HP:
1/3
Refrigeration Tons:
0.33
Voltage Rating:
Evaporator: 115V (15-amp dedicated circuit required), Condenser: 115V (15-amp dedicated circuit required)
Weight:
Evaporator: 80 lbs, condenser: 56 lbs
Amps:
Evaporator: 1 (running amps), compressor: LRA 43, RLA 8
Line Set:
Liquid line 1/4"; suction line 1/2" (less than 50 ft.), 5/8" (greater than 50 ft.)
Drain Line:
1/4” ID clear plastic tubing
Installation:
Evaporator is installed in the cellar. Condensing unit can be installed up to 100 line feet from evaporator unit.
Thermostat:
Advanced digital display (50-ft. cable), liquid-temperature-measuring bottle probe (50-ft. cable)
Temp. Delta:
Can maintain a 55°F cellar temperature with up to 110°F condenser air intake temperature

Cold Weather Start Kit

WhisperKOOL is proud to present our cold weather start kit. This kit was designed exclusively for split systems which will be installed in extremely cold environments. Split systems can be installed in a variety of ways, and the condensing unit may be located in a mechanical room, basement, backyard, or even a rooftop. The condensing units which WhisperKOOL units use were designed to operate between temperatures of 20°F and 110°F. However, there are some areas in the country which may drop below 20°F in winter.

When outside temperatures drop, the pressure in the system drops as well. This presents a challenge, because our systems operate using a pump down cycle and use a low-pressure switch to turn the compressor on and off. However, when the temperature drops below 20°F, the pressure in the system is too low to start the compressor. The cold weather start kit bypasses the low-pressure switch on startup and uses heaters installed on the receiver to raise the pressure and allow the system to start.

The cold weather start kit enables WhisperKOOL to operate in environments as cold as -20°F.

It is important that the cooling system stays operational during cold weather conditions, as heating the house using the central HVAC system will indirectly increase the temperature of the wine cellar. This kit will ensure that the cooling system will continue to operate efficiently in cold weather environments to maintain an optimal wine storage temperature.

24V Thermostat Conversion Kit

Introducing our new 24-volt thermostat conversion kit for WhisperKOOL split systems!

Utilize industry-leading technology from major manufacturers to monitor the environment of your cellar. (See individual thermostat manufacturers’ websites for details.)

  • Connect your thermostat to Wi‑Fi to control the temperature from your phone, tablet or laptop.
  • Monitor run time and energy usage.
  • Set alarm notifications.
  • View your cellar conditions from your mobile device.

The use of the 24-volt thermostat conversion kit eliminates the thermostat normally included with the system and allows your contractor to select, purchase and install the thermostat technology of your choice, including but not limited to Nest, Ecobee, and Honeywell.

By selecting the 24V Thermostat Conversion Kit, you have acknowledged that the system will not be built with the standard WhisperKOOL control or liquid measuring bottle probe. You will have to source and purchase your own 24V thermostat to run the equipment.

  • Not utilizing the thermostat from WhisperKOOL also eliminates the use of the bottle probe.
  • WhisperKOOL does not provide smart thermostats.  Those must be purchased separately.
  • WhisperKOOL customer service staff do not provide technical support for customers’ selected thermostats.

 

 

 

 

 

Manuals / Warranty Information

Manuals

Product Sheet

Warranty Information

Reviews

There are no reviews yet.

Be the first to review “Ductless Split – Ceiling Mount 4000”

Your email address will not be published. Required fields are marked *

SKU: N/A Categories: ,